Search Documents

By John W. Weeton, Donald W. Petrasek

Relatively few metal-metal systems exist that would permit the creation of fiber-metal composites consisting of mutually insoluble constituents. It is anticipated that most high strength-to-weight ratio and high -temperature fiber composites ultimately to be produced will utilize high-strength fibers embedded in a highly alloyed matrix. An investigation was conducted to determine the effect of alloying on the tensile Properties and micro-structure of tungsten-fibey-reinforced composites. Composites were made of tungsten fibers infiltrated with copper binary alloys that contain elements of varying solubility in tungsten. Room-temperature tensile tests were made on the composites, and a metallographic study of the microstructure of the fiber-metal-matrix interfaces was conducted. It was shown that, as the depth of penetration of some alloying elements into the fiber increased, a decrease in both tensile strength and ductility of the composite results. A notch effect, due to the formation of a brittle alloy zone with the tungsten fiber, was observed and gave rise to greater reductions in tensile properties and ductility behavior than would be Predicted by a law-of-mixture relation alone. In recent years, investigators have considered combining fibrous materials with relatively weak binder materials. The interest in fiber-reinforced composites results from the fact that fibers or wires may be exceedingly strong and exhibit mechanical properties superior to those of the bulk materials from which they are derived. For example, tungsten wires drawn to less than 1 mil in diameter may have strengths of over 600,000 psi,' while steel wires ranging from 10 to 3 mils in diameter may have strengths of the order of 300,000 to over 600,000 psi.2 Both metallic and ceramic whiskers are known to have very high strengths. For example, iron whiskers have been shown to have strengths of 1.9 million psi3 and sapphire whiskers have been reported to have strengths of the order of 1.7 million psi.4 If all or part of the strengths of such fibers could be retained, subsequent to the incorporation of the fibers in an engineering material, a superior material could result. In previous work done at the Lewis Research Center, McDanels, Jech, and weeton5 demonstrated the feasibility of fabricating metal-fiber—metal-matrix composites that utilized the full strengths of the fiber and matrix materials. Tungsten fibers were combined with a copper matrix by a liquid-infiltration method such that the tungsten fibers were uniaxially oriented parallel to the tensile axis of the composite. A linear relation was established that related the tensile strength of the composite with the volume percent of the fibers. Mutually insoluble constituents were selected for the study so that the strength of the composite could be quantitatively related to the strength of the individual constituents. The fact that there are only a few metals that are mutually insoluble with tungsten, e.g., copper, silver, gold, and zinc, and that these either have low melting points, high vapor pressures, or poor oxidation resistance, makes it necessary to utilize other metals that are soluble in tungsten, where high-temperature applications are ultimately contemplated. It was anticipated that, for most practical fiber-reinforced composite materials, it would be necessary to use a fiber and metallic matrix that would have varying degrees of solubility for each other. A logical extension of the earlier work was thus felt to be a study that would determine the effects of elements that had mutual solubility with the tungsten. Numerous investigators have found that tungsten fibers may be damaged by thermal treatments or contamination of the surface of the fiber by alloying elements.6-10 On the other hand, surface treatments may improve the strength of such fibers."-" Relatively little work with composites containing tungsten fibers have been reported. The work of parikh14 has shown that kinked, short-length tungsten, steel, and molybdenum fibers could str'engthen such matrices as silver, gold, and copper. Some of the combinations of fibers and matrices studied by

Jan 1, 1964

By Maurice Rey, Victor Formanek, Paul Chataignon

IT is found when floating oxidized lead ores by sulphidization, that the presence of calcium salts in the water, is usually detrimental and lowers the recovery. This effect is particularly marked in dry countries such as North Africa, where the waters often carry large amounts of calcium sulphate and where the ore may even contain gypsum.

Jan 11, 1950

JESSE L. JONES, ? Pittsburgh, Pa. (written discussion?).-From a commercial standpoint, the most important characteristic of the electric furnace is the ease with which it lends itself to intensive production. The melting of non-ferrous metals, as usually clone in crucible, open-flame, reverberatory, and similar furnaces, has certain disadvantages which are absent in the electric furnace, viz.:

Jan 4, 1919

A Foreign Policy To Protect Our Resources AGENCIES are being established in Washington to marshall raw materials and industry to build the machines of war. For the third time in less than a generation we are digging into nature's treasure trove for metals and fuels indispensable for war but equally indispensable to the peace of future generations of Americans.

Jan 1, 1951

By S. S. Arentz

An organized safety program has reduced accidents at Pioche because effort is first devoted to arousing and maintaining interest in safety, followed by training in accident prevention, assigning responsibility for the detection and removal of safety hazards, and finally, by keeping score through an adequate system of records. A health program is intergrated with the safety program.

Jan 2, 1950

By H. A. Keller

After an absence of over two years, the writer returned to Leadville in March, 1890. The change which had taken place in the conditions of smelting during so short a time seemed almost incredible. Lead-carbonates had been still further replaced by refractory sulphides, and clean dry ores had been crowded out, to a large extent, by magnesian " fines."

Jan 1, 1893

By S. K. Tarby, V. S. Robinson III

A number of experimental determinations of the vapor pressure of liquid silver have been reported in the literature. 1-8 This communication presents additional data for the vapor pressure of liquid silver measured in the temperature range of 1450° to 1600°C and summarizes the results of previous investigations. The results reported here were obtained as part of a

Jan 1, 1969

By Fathi Habashi

Nickel, copper, and elemental sulfur can be recovered from a low-grade pyrrhotitepentlandite type concentrate by leaching with HNO3 in a pressure reactor at moderate temperature and pressure. The bulk of iron is converted to an oxide. Same results can be achieved by leaching in an open vessel under a reflex condenser for an extended period of time.

Jan 1, 1974

By R. W. Raymond

By the death of Bergrath Prof. M. F. Gaetzschmann, which occurred on the 18th of February, in the 95th year of his age, at his lifelong home in Freiberg, Saxony, the Institute loses one of its earliest and most eminent honorary members, and the profession of mining and engineering one of its most influential and useful representatives,

Jan 1, 1896

By Persifor Frazer

THERE is always a difficulty in assigning limits to the scope of a science or art, and among the difficulties of that kind besetting practical or stratigraphical geology is that of determining what kinds of natural objects shall be considered as the goals of its search. The term mineral, in its broader sense, includes every solid, liquid, or

Jan 1, 1875

By E. C. Wade, R. D. Valentine

This paper describes a computer applications engineering system and it's use to apply a thermal dryer fan motor in a coal preparation plant. The computer hardware and software systems are described to indicate the general approach taken and a specific case study is reviewed to show how computer power is brought to projects in the coal industry.

Jan 1, 1983

By E. P. Pfleider, C. A. Dufresne

The problem of mooing open-pit ores over large vertical distances is increasing in importance because of the immense deposits being mined. Gravity fall of ore through transfer raises to central haulage points underground has advantages for certain open-pit operations, and this method is being seriously considered for the Carol Project now underway in Canada.

Jan 6, 1961

By Persifor Frazer

There is always a difficulty in assigning limits to the scope of a science or art, and among the dificulties of that kind besetting practical or stratigraphical geology is that of determining what kinds of natural objects shall be considered as the goals of its search. The term mineral, in its broader sense, includes every solid, liquid, or

By Erwin S. Sperry

Brass or bronze chips, grindings, buftings, washings, and miscellaneous scrap metal sooner or later find their way into the hands of the so-called metal-smelter or " refiner," whose refining or smelting operation consists simply in melting the material, adding the requisite amounts of other metals, and then casting it in the form of ingots, which are afterwards sold

Jan 1, 1899

By R. E. Hummel, J. W. Koger

SINCE the first report about a diffusionless transformation of bcc p1 brass to tetragonal p" in 1936 by Kaminski and Kurdjumov,' a series of papers have been published about this transformation, mainly dealing with the temperature range of the martensitic-start temperature (M,) and with the crystallographic structures of the parent and product phases .s In the

Jan 1, 1969

By L. G. Laureau

This paper is presented to call the attention of steel-manufacturers to the need of further reform in the manner of casting and handling ingots. The problem of making the work usually performed in and around the casting-pit less dangerous to the men and less costly to the management is one which has occupied the minds

Jan 1, 1885

By M. Dayne Aldridge

A discussion of the definition of automation in mine ventilation applications is presented. The results of theoretical studies, experiments, and practical experience from work in the United Kingdom, Belgium, Poland, the Soviet Union, and the United States are summarized Conclusions are drawn from these efforts and the prospects for the future development of automatic mine ventilation systems are explored.

Jan 1, 1980

By A. N. Roberts, N. W. Stump

New developments in on-stream analysis using immersed radioisotope gages including results from plant installations are described. The control of grinding and flotation using a small digital computer has been complemented by this development. A control scheme for grinding, which is based on maximum throughput at constant product size, and preliminary work in flotation control are also outlined.

Jan 1, 1975

By Chas. A. Ashburnea

THE appliances which have been proposed, and the modifications in the construction of boiler-furnaces which have been made for the prevention of smoke, and the utilization of what are ordinarily called the waste products of combustion, have been innumerable.† †There is now open in London an exhibition "of apparatus of all kinds devised to prevent smoke."

Jan 1, 1882

By E. L. Mooney, D. F. Gibson, T. E. Lehman

This paper outlines the features of a computerized planning system, which was developed to aid surface mining and reclamation evaluation. Essential features of the system include three main modules: production, reclamation, and impact analysis. In addition, the system incorporates a large number of computerized data analyses and display features, which are described and illustrated in this paper.

Jan 1, 1983