Search Documents

In February 1974 a continuous synthetic polymer dosing plant was installed at Hamersley Iron Pty. Limited's Pellet Plant at Dampier. The polymer, supplied in a liquid sus- pension, is used to improve the drying characteristics of green pellets. 'Three years of test work were involved in the development of the use of polymers. Polymer is continuously dosed to the balling spray water system at a rate determined by the flow of spray water to the discs. Problems have been experienced with handling the polymer in 44 gallon drums, the increased viscosity of the spray water, disc overloads, increased bed strength and increased "stickiness" of pellet fines.

Jan 1, 1974

Economic mathematical methods have been developed and applied in the design, planning, development and managing stages in the mining industry. Economic and technological efficiency is achieved with the aid of a large range of probability models, which are used to enable decisions to be made progressively during the different stages. The entire operation is considered as a total system made up of sub- systems and the models representing these are consecutively interrelated with each other. Algorithms and programmes representing the economic mathematical models for all the stages involved were tested and were found to be applicable to the various important mines in the Donetsk basin. Currently, these models are accepted and widely used.

Jan 1, 1977

The main objectives of this paper are to identify the main sources of coal dust and to investigate measures for minimisation of dust generated at these sources at the Bukit Asam open cut mine, on the island of Sumatera, Indonesia which uses a

Jan 1, 1994

The impact of moves to introduce Abori- ginal land rights was felt in the Northern Territory as early as 1972 when the Federal Government froze the processing of all appli- cations for mining interests over vacant Crown land. The Aboriginal Land Rights (Northern Territory) Act was finally proclaimed on Aust- ralia Day 1977 and since that date the mining industry and the Territory legislature have struggled to make the Act work. Despite these efforts long delays have been experienced by those required to negotiate mining and explor- ation agreements under the Act. In fact explor- ation on Aboriginal land has been effectively stiffled since the introduction of the Abori- ginal Land Rights Act. The Northern Territory government and the mining industry have both sought amendment to the Act to remedy some of its more onerous problems. These efforts have generally been fruitless. Some of the recommendations put forward by Mr Justice Toohey following his recent review of the Act would provide relief in some important areas. However, any such improvements are more than offset by a number of Mr Justice Toohey's recommendations which would severely disadvantage the vast majority of Territorians. A recent survey of mining companies seeking exploration licences over Aboriginal land indicates that many of the existing diffi- culties could be overcome without significant amendment to the Act but rather by the adoption of a positive administrative approach by the Land Councils. It is now up to the Commonwealth and the Land Councils to demonstrate that their Act can work without crippling the Northern Territory economy and its mining industry.

Jan 1, 1984

By Kurzeme M, Willoughby D. R

The current approach to the design of fill, as a structural component in a mining system, is based on traditional usage, previous experience, empirical rules and preconceived ideas. This approach does not permit the relative economicsof the various possibilities to be evaluated, retards introduction of new materials or processes, and results in fragmented fill research effort.A rational approach to the design of fill is proposed as a means of overcoming these disadvantages.This is based on five components:(a) statement of functions of fill,(b) definition of modes of fill response,(c) criteria of satisfactory performance,(d) analysis of fill response,(e) specification of required fill properties and methods of obtaining them.An assessment of each component indicates that the adoption of this rational design approach will require research effort in categorising modes of fill response and in defining criteria of satisfactory performance.

Jan 1, 1973

The Plant Control and Data Logging System for the Loy Yang Open Cut (LYOC) is part of a control and communications network designed to provide a high level of surveillance of open cut plant and facilitate the efficient co- ordination of operations and plant maintenance. The computer system selected utilises a central dual mini-computer and multiple microcomputer data transmission network ,linked to the plant controllers using distributed, microcomputer based remote data collectors or outstations. Several aspects of the computer system are outlined.

Jan 1, 1982

By De Carvalho J

The average installed refrigeration capacity on South African gold mines has increased by about eighteen per cent annually for the past 15 years; both the number of installations and their duties have increased. One consequence of these large refrigeration installations is that careful attention must be paid to the system for distributing cold water. In these distribution systems, devices which minimize the temperature rise of the water delivered to the underground workings and which also reduce the pumping requirements for returning the water back to surface are used. In this paper the suitability of these various devices are examined and with the aid of a specially developed computer program their optimum operating conditions are determined. In addition the optimum combination of surface and underground refrigeration plants is examined for a hypothetical mine at various depths and the importance of pump efficiency on total distribution costs is discussed.

Jan 1, 1988

The paper describes some of the economic and human factors associated with haulroads on Mount Whaleback, a large open pit iron ore mine. These factors have combined to encourage formation of a specialised road maintenance crew which caters for haulroad construction and maintenance. Techniques used for design, construction, operation and management of haulroads are then described. Future developments are expected to effectively lower construction costs leading to an even wider application of the techniques described and consequent improvement in temp- orary roads and overall truck performance. INTRODUCTION Mount Whaleback is a large truck/shovel open pit iron ore mine located in the Pilbara region of north Western Australia. Annual production capacity exceeds 100 million tonnes per annum of waste and ore. The truck haulage fleet comprises WABCO 120 52 WABCO 3200 22 74 of which approximately 45 are operating at one time.

Jan 1, 1982

By H Jha, M C. Thomas, P Gupta, S K. Sit

The modern jig with a state-of-the-art control system is much more effective than its older version. This improved control system is used to modulate the amplitude and the frequency of the jig cycle. These two prime parameters are optimised with respect to feed characteristics for best jigging performance. Based on this understanding any jigging plant can be optimised. In addition to these established facts present study shows process efficiency improves further through optimisation of the feed quality.

Jan 1, 2007

Deposition of uranium in the South Alligator river area has been influenced structurally by reverse faulting; and lithologically by carbonaceous shales and sandstones. Mineral assemblages suggest a mesothermal-epithermal epigenetic mode of origin. The ultimate source of the uranium and associated metals is probably in deep seated magmatism which is expressed at surface in the widespread penecontemporaneous vulcanity.

Jan 1, 1968

By Yaroshenko YuG, Bokovikov BA, Gordon YaM

Problems of the effect of the number of tuyeres and their parameters on the uni- formity of gas distribution are invest- igated with the use of the authors' devel- oped mathematical model of the movement of gases and materials in the blast furnace. It is shown that the improvement of uni- formity of gas distribution with an increase in the number of tuyeres has a damping character. An analysis of the errors of the specified assumptions of the hypothesis concerning the potentiality of the gas movement in the bed is carried out. It is established that the potential approach model gives good results with the determination of the discharge of gas and its stress field, but is not useful for the calculation of local velocities of gas in the raceway. The results of trials of calculation investigations of the dynamics of form- ation of the raceway and the voidageòfield in beds of burden materials are presented in the concluding part of the paper.

Jan 1, 1981

Production scale experiment study was carried out in a limestone open-pit for testing the theory and method proposed by the author(Zou, 1987). The results of experiments indicate that the mathematical model and computer programs, which include the consideration of both the three dimentional distributions of the weak planes and the energy densities of explosion stress waves, reflect the physical process of rock bench blasting quite well. The predicted fragment distributions coincide well with the practical fragment distributions measured with the photo-image analysis method proposed by the author(Zou,1989). The paper "A Three Dimensional Mathematical Model for Calculating the Rock Fragmentation by Bench Blasting in the Open-pit"(Zou,1987), which was published in some conferences and journals, has interested some scholors and researchers. In order to test and improve the model, a group of production scale experiments were carried out in a limestone open-pit during 1986-1987. The procedure and results of the experiments are illustrated in this paper.

Jan 1, 1990

Concrete has been used for many years in block caving, principally for drift and drawpoint linings. This paper describes the requirements for concrete in this application, the required properties, the mix design, and transportation and placement systems. In addition a concrete mix design rationale is also proposed.

Jan 1, 2000

In reviewing recent developments in the process mineralogy of gold it is convenient to distinguish between visible (>0.1 pm) and invisible gold (1 - 2 pm in size in polished section; these can scan the surface of a polished section, identifying the gold minerals, recording co-ordinates of the grains for subsequent examination, and making measurements of areas and sizes of the grains. However, problems of sample reliresentivity in polished section mean that such data may not give good quantification of gold mineral proportions and liberation/locking characteristics and other methods are required for this (amalgamation, cyanidation, ultra-fine milling and cyanidation). Characterisation of invisible gold in bulk material (eg a sulphide concentrate) can be done by mineral separation, ultra-fine milling and cyanidation or by quantitative point analyses of a large number of mineral grains. Analytical methods include electron microprobe analysis (detection limit normally -200 ppm but -10 ppm by using special techniques), ion microprobe analysis (secondary ion mass spectrometry - SIMS; detection limit -0.2 ppm) or proton microprobe analysis (PIXE; detection limit

Jan 1, 1992

By T S. Fayram

The successful application of flotation is now over one hundred years old. However in a practical industrial sense, it still remains predominantly an art rather than a quantifiable science. Moreover, the laboratory testing, interpretation and application of the technology can still be tedious, time consuming and costly. This paper outlines the use of proven statistical design of experimentation software for rapid optimisation of flotation testing with limited representative sample utilisation. This results in less costly required testing, a more thorough understanding of results and the ability to simultaneously optimise several variables and outcomes at once. At the Center for Advanced Mineral and Metallurgical Processing, this testing methodology has been used successfully in many metallurgical development and plant optimisation projects thereby confirming its real world utility and application.

Jan 1, 2005

A review of ground control procedures in Western Australian underground mines is presented. Geotechnical input into initial mine design and methods of ground control is rare. As a result, the frequency of unexpected rockfalls is comparatively high, with over three quarters of the mines adopting non-specialist ground control designs experiencing unexpected falls-of-ground. In contrast, mines that provide some level of specialist input into initial ground control design experience decreased rockfall frequencies.

Jan 1, 1992

By Jifan X, Yongyu W, Liangjing L

Shallow interception of groundwater is a special dewa- tering form in the specific geological and hydrogeological conditions. It has an economic and technical effect. The roof of the Fankou Lead-zinc deposit is the Hutianqun aquifer made up of the limestone of the upper Carboniferous system. - A "water-bearing basin" is surrounded by the aquifuge and the aquitard below ¦0 m level at the Shiling Hill section in the Hutianqun aquifer. Based on the natural conditions, an interception gallery is excavated at -40 m level out of "the water- bearing basin", the other gallery excavated at ¦0 m level in the poor water-bearing zone of the Jinxing Hill. During 20 years of experience, the better interception effects have been gained.

Jan 1, 1988

In December 1997, a series of new environmental legislation was enacted including:ò Environmental Planning andAssessmentAmendmentAct 1997; ò Contaminated Land ManagementAct 1997;ò Protection of the Environment (Operations) Act 1997; ò Native Vegetation Conservation Act 1997; andò Pollution Control (Load Based Licensing) Act 1997.These new Acts will have varying degrees of impact on the coal mining industry in New South Wales when they commence later this year.

Jan 1, 1998

In formulating its strategic plan in 1998 the New Zealand Minerals Industry identified two related critical issues facing it. These are, broadly speaking, the issues of access to minerals; and the perception the public has towards the industry and its behaviour towards the environment. This presentation will report on the Industry's response to the public perception issue. The Industry has, through the NZMIA Council, and its Communication and Website Committees, developed and implemented strategies covering: communication through the print media, and through its website www.minerals.co.nz, a long-term educational outreach programme with schools, focussing on the significance of minerals, their contribution to community wellbeing and the negligible long-term environmental effects of the Industry's activities.

Jan 1, 2000

Integrated chemical thermodynamic software and computerised databank systems have evolved over the last 15 years. The extent to which these systems have automated thermodynamic calculations relevant to extractive metallurgy is examined. The scope for further automation and the role of the expert consultant is discussed.

Jan 1, 1991